Part 1 – General – VB350 16 mil

1.1 Section Includes

A.  Products supplied under this section

1.  Vapor Barrier and seam tape for installation under concrete slab

1.2 Related Section

A.  Section 07260 – Under Slab Vapor Retarder

B.   Section 03300 – Cast-in-place Structural Concrete

1.3 References

A.   American Concrete Institute (ACI)

1.  ACI 302.1 R – 96 – Vapor retarder / barrier membrane is greater than or equal to 10 mils in thickness

B.  American Society for Testing and Materials (ASTM)

1.  ASTM E 96 – Water vapor transmission of materials

2.  ASTM E 1745 – Water vapor retarder used in contact with soil or granular fill under concrete slabs
 

3.  ASTM E 154 – Water vapor retarder used in contact with earth under concrete slabs, walls, or ground cover
 

4.  ASTM E 1643 – Installation of water vapor retarder used in contact with earth under concrete slabs

1.4 Submittals

A.  Submit manufacturers product data and installation instruction

B.   Submit laboratory test results showing compliance with ACI and ASTM standards

C.  Submit manufacturers product samples

Part 2 – Products – VB350 16 mil.

2.1 Manufacturer

A.  Barrier-Bac, 9 Peach Tree Hill Road, Livingston, NJ 07039,

973-994-8035 * Fax: 973-740-8244

2.2 Materials

A.  High density polyethylene vapor barrier
 

1.  Description: Three layer coextruded biaxially oriented polyethylene membrane

 

2.  Water vapor transmission ASTM E – 96 less than or equal to 0.007 g / m2 *h
 

3.  Tensile strength ASTM D – 882 minimum 63 lbs / in

4.  Permeance ASTM E – 96 less than or equal to .009 perms

5.  Puncture resistance ASTM D – 1709 greater than or equal to 2226 grams

2.3 Accessories

A.  Seam tape 1. 8 mil PVC tape with rubber/resin adhesive. Tensile strength not less than 22 lbs./inch minimum per ASTM D 882.  Minimum width 4 inches.

B.  Pipe Boots 1. Follow manufacturers instruction to construct pipe boots with vapor barrier membrane and seam tape


Part 3 Execution

3.1 Examination

A.  Examine surfaces to receive membrane. Notify architect if surface is not acceptable

3.2 Surface Preparation

A.  Tamp and level or roll surface to receive membrane

3.3 Application

A.  Installation of vapor barrier

1.  Install vapor barrier in accordance with ASTM E 1643-93 and manufacturer’s instructions

2.  Unroll vapor barrier with longest run in pour direction

3.  Lap vapor barrier over footings

4.  Seal vapor barrier laps to foundation walls

5.  Vapor barrier should be overlapped four inches at joints and sealed with Barrier-Bac Inc.’s seaming tape

6.  All penetrations must be sealed with pipe boot made using vapor barrier membrane and seam tape
 

7.  Seal all damaged areas in vapor barrier with membrane patch according to manufacturer’s instructions

3.4 Protection

A.  Protect membrane from damage until placement of concrete